Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Dabaiya
Tank welding in Dabaiya addresses leaks and cracks in tanks exposed to harsh heat and moisture. We pinpoint leak sources precisely, weld the cracks and test the tank at full volume.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Water tanks in southern Dabaiya suffer salt and moisture damage because although distant from the sea, soil holds high groundwater. Plastic and fibreglass corrode gradually from salts and moisture, especially at the base where mineral deposits pool. We need careful inspection of the base and lower corners, scraping white deposits that weaken material before welding. If corrosion runs deep we add a fibreglass patch to reinforce the area before final welding.
Dabaiya sits in southern Ahmadi on damp soil where tanks face corrosion from ongoing salt and groundwater moisture.
After welding, we rinse the tank with fresh water to remove residual moisture then let it dry completely before refilling.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Dabaiya
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Dabaiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Are white salt deposits on tank walls dangerous?
Yes, salts weaken plastic and fibreglass gradually and make material prone to cracking under stress. We carefully scrape them and inspect the surface under magnification to assess damage before welding.
Can the tank be sealed permanently with water barriers?
Barriers stop leaks temporarily but do not fix underlying cracks and weakness. We weld the cracks first then apply an extra protective barrier to the outer surface to prevent new moisture.
