Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Dajeej
Tank welding in Dajeej focuses on repairing cracks and loose joints in plastic tanks that withstand desert heat. We reach the damage site, treat the crack with thorough cleaning and a tight weld that resists internal pressure. The tank then holds water without loss.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Dajeej desert zones have scattered houses, sheds and old wells, most with large plastic tanks exposed to direct sun year-round. Summer temperatures reach fifty degrees Celsius, causing cracks in tank walls and metal fittings. Cracking starts small at a joint then spreads under hydrostatic pressure, so we need a strong weld that survives constant expansion. If the tank sits in a shed or well, access from the side and top is usually clear.
Dajeej is a desert zone in Farwaniya governorate, where large water tanks are essential for water storage.
Every weld is tested under compressed air pressure for five minutes before the tank is refilled for use.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Dajeej
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Dajeej
Need someone now? The emergency line is open any hour.
+965 9668 4964
My large tank has multiple heat cracks. Can it be repaired or must it be replaced?
If cracks are at joints and fittings, welding repairs them, but if they spread across the tank walls themselves, replacement may be better. We inspect the tank first and suggest the strongest option.
After welding, how long must I wait before refilling the tank?
Immediately after welding we test the joint with pressured water to confirm it is sound. You can refill the tank one hour after work is finished.
