Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Ardhiya Industrial
Tank welding in Ardhiya Industrial fixes cracks and leaks in plastic and fibreglass tanks serving factories and workshops. We inspect the full tank, locate the break, drain the water, prepare the surface and weld it at controlled heat for a complete seal.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Tanks in Ardhiya Industrial bear high pressure because continuous production needs steady flow, and a cracked tank stops work and may damage the surrounding floor. We trace the leak under pressure before heating, because heat can alter how the crack runs. Most industrial tanks are deep and heavy, so we need strong drainage and bracing while welding.
Ardhiya Industrial sits in Farwaniya governorate, a factory and workshop zone where operations depend on tanks that hold steady and do not leak.
Every weld is tested by filling the tank and holding it under full pressure for six hours before handover.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Ardhiya Industrial
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Ardhiya Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can welding happen while the tank is connected to production lines?
No, supply and waste lines must be isolated and the tank completely drained first. This protects machines from hot water and fumes, and lets us inspect the full surface and apply heat safely.
What if the crack is near the top opening or the bottom outlet?
Cracks near openings need extra care because the metal there is thinner and weaker. We prepare carefully around the opening and widen it slightly if needed to apply even heat without damaging the rim.
