Crack welding
direct thermal weld along each fracture line in the tank wall
Mubarak Al-Kabeer
Tank welding in Funaitees
Water tank welding in Funaitees tackles cracks and leaks from large plastic tanks serving residential buildings and blocks. We inspect each tank under air pressure and pinpoint the leak. We scrape the surface, weld the crack with the matching rod and test the repair by filling the tank completely.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Funaitees holds mid-rise residential buildings with overhead tanks mounted on concrete frames. Leaks from top fittings are common here because older tanks have metal connectors weakened by rust. We inspect fittings and outlets first before checking the tank body, measure internal pressure to determine if the leak is from walls. Modern plastic tanks here have exposed drain pipes we also check inside.
Funaitees is an area in Mubarak Al-Kabeer governorate near city centres and holds residential buildings with complex water supply systems.
We run the tank at full flow for one hour after repair to confirm all fittings and walls hold pressure without leaking.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Funaitees
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Funaitees
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does rust on metal fittings mean replacing the whole tank?
No, we can replace rusted fittings and pipes with corrosion-resistant plastic ones. The tank body may remain safe if the structure is sound. We inspect walls first before deciding replacement.
Does repeated repair affect tank safety?
One or two repairs are completely safe if the weld is strong and the surface clean. But if cracks recur in the same spot that signals wall weakness and we recommend replacement.
