Crack welding
direct thermal weld along each fracture line in the tank wall
Mubarak Al-Kabeer
Tank welding in Qurain
Tank welding in Qurain usually starts on the roof, where years of sun make the top of a polyethylene tank brittle around the lid. Before any weld, we check how far the brittleness has spread, because a sound tank with one crack is worth repairing and a crumbling one is not.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
On Qurain rooftops, the lid ring takes the worst of the heat and foot traffic, and cracks tend to start there. We press and flex the surrounding plastic to see whether it is still flexible, clean the crack back to fresh material, and drill a small stop hole at each end so it cannot run further. The weld is built up in layers with a matching rod, then smoothed so the lid seats flat again.
Qurain is a Mubarak Al-Kabeer governorate suburb where family homes typically keep polyethylene water tanks on the roof.
Every crack we weld in Qurain gets a stop hole drilled at each end before the first layer goes on.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Qurain
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Qurain
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do I know if my tank is too brittle to weld?
If the plastic around the crack flexes, it can be welded. If it snaps or powders when pressed, replacement is the honest advice.
Why does the crack start near the lid?
The lid area gets the most sun and the most handling. Heat and repeated pressure there weaken the plastic first.
