Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Hassawi
Tank weld repair in Hassawi starts when a homeowner notices a leak from a joint or small crack in the plastic tank body. We unbolt the tank from its supports, fill it under pressure to locate the leak precisely, then dry and clean the surface before hot-wire welding the crack.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Single and two-storey Hassawi houses have varied rooftop tanks: some are heavy-gauge plastic one millimetre thick, others are thin-layered fibreglass. When we are called near Hassawi Co-op we first check the leak site under water, because a small crack may not show from outside and damp around the tank hides the real spot. We test the weld by refilling the tank and running it for one hour before we declare it sound.
Hassawi sits in Farwaniya governorate, an older residential district where rooftop tanks are common because of seasonal pressure drops.
At every repair we record the cooling temperature of the weld surface because insufficient heat leaves tiny pores that leak slowly.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Hassawi
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Hassawi
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a tank be welded while it is full of water?
No, we empty the tank completely and let it dry for two hours before welding because water cools the joint and weakens it. We fill it under pressure only to test the repair after we finish.
What if the crack runs along the full length of the tank body?
We divide a long crack into sections and weld each section separately with cooling intervals between them. After each section we test for leaks before moving to the next.
