Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Sabah Al-Nasser
Tank welding in Sabah Al-Nasser treats cracks and leaks in plastic and fibreglass tanks spread across house and villa roofs. We assess each tank and choose the right welding method by material and damage. We clean the surface, weld cracks and pressure-test the tank before finishing.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Sabah Al-Nasser near the Sixth Ring Road has modern villas and homes with contemporary water tanks, mostly sturdy fibreglass or plastic. This area faces strong winds and heavy dust that increase mechanical pressure on tanks. Joints and the base are first points for wear and leaking. We check for wear marks and small surface cavities that may not be obvious. We use dyed water to pinpoint fine leaks before starting any weld.
Sabah Al-Nasser lies in Farwaniya governorate along the Sixth Ring Road, a modern residential area with water tanks exposed to high environmental stress.
We test the tank by pumping water and air together to find fine leaks that filling alone may miss.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Sabah Al-Nasser
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Sabah Al-Nasser
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do Sixth Ring Road winds affect water tanks?
Yes, strong winds increase pressure on tank walls and may cause cracks over time. We check for mechanical stress marks and cracks starting from edges. If the tank sits in a very exposed spot, we suggest stronger fixing or added protection.
Are fibreglass tanks better than plastic in windy areas?
Fibreglass is stronger against wind and mechanical pressure because the material is stiffer. Thick plastic may be adequate if wall thickness is enough. We advise you at purchase based on tank location and wind strength in your area.
