Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Kaifan
Tank welding in Kaifan addresses leaks and cracks in plastic and fibreglass tanks on rooftops of villas and residential blocks. We pinpoint the leak location, weld the crack with controlled heating and refill the tank to verify the repair.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
In Kaifan modern villas have large tanks on rooftops near air conditioning vents and solar panels, making access difficult and cracks common from intense heat. When old tank weld seams split from expansion and contraction, water drips onto the upper room wall or pools around the tank base. We need to measure the space carefully and sometimes move pipes and panels to reach the crack, then weld it from both sides under full water pressure.
Kaifan is a residential district in Kuwait governorate with modern villas near Kuwait Sporting Club, where rooftops are crowded with equipment.
Before leaving, we run a hose over the weld at full pressure to ensure no water seeps through.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Kaifan
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Kaifan
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is fibreglass tank welding harder than plastic tank welding?
Fibreglass is stronger and can have deeper cracks without collapsing, but welding needs higher heat and care against thermal collapse. We use fibreglass-specific materials and allow slow cooling before refilling.
What if the tank sits on concrete pillars?
We climb the pillars or use a long ladder and inspect tank seams from below as well, because leaks often come from lower wall edges. Welding underneath is harder but necessary if the crack is there.
