Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Rai
Tank welding in Rai addresses mechanical failure of large storage tanks in commercial malls and retail centers where water demand is constant. Commercial tanks work under steady pump pressure, stressing original welds. We isolate the failure point from the rest of the system and weld the crack under engineering oversight.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
The commercial zone in Rai around The Avenues and IKEA holds multi-use buildings and light industrial facilities. Each commercial building maintains large rooftop tanks of fibreglass or stainless steel to ensure stable water supply throughout the day. Large tanks bear heavy weight and endure strong pump pressure, concentrating stress on lower and side joints.
Rai is a wide commercial zone in Kuwait governorate near The Avenues Mall and known for large retail stores and service facilities.
We test the commercial tank under actual operating pressure because leaks may not show under low test pressure.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Rai
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Rai
Need someone now? The emergency line is open any hour.
+965 9668 4964
If a commercial tank leaks during business hours, can it be fixed without closing the store?
Yes if the leak is in an upper joint. We isolate the tank from the system to stop water flow, then weld the crack quickly. Most repairs finish in one to two hours.
Will the commercial tank work at full pressure after the crack is welded?
Yes, correct welding restores the tank's original strength. We test under actual pump pressure before reconnecting to the system. The new weld lasts as long as regular maintenance keeps running smoothly.
