Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Qortuba
Tank welding in Qortuba addresses cracks in plastic storage tanks that have suffered long-term pressure or direct impact. We locate the leak by filling the tank and tracking water drops, then clean the surface and seal the crack with specialist welding rod. The repair is tested under full pressure before the tank returns to service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
The upscale Qortuba homes often house elevated fibreglass or reinforced plastic tanks on roof structures or in plant rooms. These tanks experience daily thermal expansion and contraction, causing mechanical cracks around joints and seams. When moisture appears around the tank base or on adjacent walls, we inspect the body for weak points near the lower connection area.
Qortuba lies in Kuwait governorate, an upscale residential zone where each villa relies on its own elevated water tank.
Every weld is tested by filling the tank to full capacity because small leaks only show under actual working pressure.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Qortuba
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Qortuba
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a long crack in the tank be repaired or must it be replaced?
If the crack lies in one area and has not spread near the lower joints, it can be welded shut. We assess the crack first and confirm the surrounding material is strong enough to accept the weld.
How long before the tank can be refilled after the weld is done?
Two hours after the final weld, once the welded area has cooled completely. We leave the tank open to air while cooling, then refill it slowly in small increments to test the repair.
