Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Khitan
Tank welding in Khitan often centres on the inlet, where the float valve is fixed. When mains pressure returns after a cut, the valve can slam and shake its fitting, and over time the plastic around that boss cracks on tanks near Khitan Co-op and Farwaniya Hospital.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
In Khitan, welding the inlet boss without dealing with the shock only buys time. We remove the float valve, weld the cracked boss back to full thickness with a backing ring, and refit the inlet with a support bracket so the pipe cannot lever the tank wall. Where the incoming pressure is high, we replace the old valve with an equilibrium type that closes gently and keeps the fitting from being hammered each time the tank fills.
Khitan is a Farwaniya governorate district near Farwaniya Hospital, served by Khitan Co-op and dense with family homes.
Cracked inlet bosses we weld in Khitan are refitted with a support bracket so the pipe cannot lever the wall.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Khitan
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Khitan
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does my tank bang when the water comes back?
The float valve closes suddenly against high pressure. An equilibrium valve closes more gently and stops the shock.
Will the crack return if only the tank is welded?
It can, if the inlet keeps hammering. Supporting the pipe and changing the valve deals with the cause.
