Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Khitan Al-Jadida
Tank welding in Khitan Al-Jadida fixes cracks and leaks in older plastic and fibreglass tanks that have lost seal. We inspect the whole tank, find the damage, repair failed joints, weld cracks and pressure-test before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Khitan Al-Jadida houses have a roof tank because the area was built with weak distribution pressure in early years. These tanks face sun and intense heat daily, which makes plastic and fibreglass joints crack after ten years or more. When we arrive to repair a leaking tank, we lower it gently, drain it fully and open suspect areas to judge whether cracks are deep or surface.
Khitan Al-Jadida lies in Farwaniya governorate, a residential district where most homes have roof tanks that need routine inspection.
Every repair is tested by filling and waiting one hour because fine cracks may not show immediately after welding.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Khitan Al-Jadida
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is my old tank worth repairing or should I replace it?
If the tank is under fifteen years old and cracks are few and in one spot, repair costs far less. We inspect visually and under pressure first, and advise replacement only if cracks spread across multiple areas.
After welding, will the tank return to its original strength?
Proper welding restores the joint fully, but the tank material itself may be brittle from sun exposure. We test at high pressure after repair to ensure other old joints will not fail soon.
