Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Mahboula
Tank welding in Mahboula focuses on repairing fibreglass and plastic tanks damaged by salt exposure or intense pump pressure. We locate cracks and leaks through thorough inspection and controlled pressure, then weld them with a technique that prevents reoccurrence.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Many Mahboula villas and shops near or on the waterfront have leaking tanks due to coastal moisture and salt damage to fibreglass. Long cracks can run from the tank base to mid-height, especially if sun exposure is intense all day. We climb to the roof, open the tank cap and clean the interior, drain it completely and leave the walls to air-dry for hours before welding each crack with a fibreglass-specific torch.
Mahboula sits in Ahmadi governorate on the southern coast, a seafront zone where tanks face constant salt and moisture exposure.
After welding, we leave the tank open to air for at least one hour before refilling, because steam can affect weld quality.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Mahboula
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Mahboula
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does coastal salt damage cause leaks to return quickly after welding?
No, if the entire crack length is welded solidly and the tank is tested under full pressure. We use salt-resistant welding wire that lasts years without new corrosion.
Can a tank be welded while it still holds water?
No, it must be completely free of water and moisture because water prevents the weld from bonding and penetrating. We drain it fully and dry the walls and base before any welding starts.
