Crack welding
direct thermal weld along each fracture line in the tank wall

Ahmadi
Tank welding in Dhaher addresses cracks in fibreglass and failed joints on tanks isolated by sand and extreme heat. We inspect each surface for fibre weakness and reweld joints under full pressure.
Fibreglass tanks in the Dhaher desert zone endure cyclical expansion and contraction from large day-night temperature swings, placing stress on joints and the base. Tanks buried in sand need careful inspection because sand moisture attacks the outer fibreglass surface and causes weakness under the shell. We carefully dig around the crack to see the fibre layers and check whether the separation runs deep into the build or sits only on the surface.
Dhaher sits in Ahmadi governorate near the Saudi border, a desert region where buried tanks freeze nearly solid in winter and run extremely hot in summer.
After welding, the tank sits sealed without flow for three hours to cool the welds before we fill it slowly and check leaks at each section.
direct thermal weld along each fracture line in the tank wall
re-welding inlet and outlet fittings where the flange joint has failed
resin-and-mat layer over the damaged zone before the final weld seal
internal camera after welding reveals any weak point before refilling
replacing the tank lid when the leak source is the cover seal
written record of weld locations and camera inspection result
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, we reduce welding speed on very hot days and use light water mist to cool the surface during work. The weld becomes stronger when cooling is slow, so we avoid rapid cooling that creates internal stress.
Damp patches around the tank site and saturated sand suggest ongoing leaks, usually from cracks on the tank side touching the sand. We dig carefully and use coloured water to trace the leak path to hairline cracks.
