Crack welding
direct thermal weld along each fracture line in the tank wall
Mubarak Al-Kabeer
Tank welding in Masayel
Tank welding in Masayel starts with a thorough inspection of cracks and leaks in the tank body. We locate the leak under pressure, clean the weld zone carefully and apply the right heat to seal the crack permanently.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Masayel residential houses use plastic tanks mounted on two- and three-storey rooftops, exposed to sun and constant thermal expansion. When a crack appears in the tank wall or around the filler neck we stop supply at once and drain the tank partially to allow safe access. We scrape the crack carefully with a fine file to reach sound edges, then pass a heat gun over the zone to fuse the plastic back together.
Masayel is a residential zone in Mubarak Al-Kabeer governorate, where plastic roof tanks are relied upon for seasonal water storage in family homes.
After welding we refill the tank gradually and watch the repair site for an hour to confirm the leak does not return.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Masayel
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Masayel
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a crack in the tank bottom be repaired from inside?
No, the tank must be completely drained and accessed from outside to clean the crack properly. If the bottom is very thin we may recommend replacing the tank instead of rewelding.
How long before the tank can be used again after repair?
After welding and cooling we refill gradually and monitor the repair. If no leak appears within an hour the tank is ready for normal use.
