Crack welding
direct thermal weld along each fracture line in the tank wall
Mubarak Al-Kabeer
Tank welding in Qosor
Tank welding in Qosor addresses leaking seals and cracks in plastic and fibreglass tanks. We pinpoint weakness by filling the tank under pressure, then repair it through careful cleaning and steady heat application to the damaged zone.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Qosor in southern Mubarak Al-Kabeer holds family houses and villas with roof tanks running year-round. The fibreglass tanks there are prone to cracks around openings because the layers move with thermal change. We inspect the joint between opening and tank body carefully and stop the pump before work begins. We gently sand the crack, apply a reinforcement strip over it and pass heat to fuse the layers.
Qosor sits in south Mubarak Al-Kabeer, where temperatures reach high levels throughout the summer season.
We test the joint with low-pressure water injection before full filling to avoid straining the fresh repair.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Qosor
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Qosor
Need someone now? The emergency line is open any hour.
+965 9668 4964
Are fibreglass tanks less prone to cracking than plastic?
No, fibreglass cracks more easily around openings because its layers move independently. But the cracks are easier to repair because they do not spread quickly like plastic does.
What if the leak is from the inlet pipe, not the tank body?
We disconnect the pipe from the fitting and check the thread and seal. If the seal is damaged we replace it, and if the thread is cracked we rewrap the pipe with sealing tape and retighten.
