Crack welding
direct thermal weld along each fracture line in the tank wall
Mubarak Al-Kabeer
Tank welding in Abu Fatira
Water tank welding in Abu Fatira focuses on repairing cracks and broken fittings in large tanks for houses and villas. We inspect the full tank and pinpoint leak location accurately. We prepare the matching welding rod and weld the crack after scraping the surface and test the repair under full pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Abu Fatira homes use both overhead and ground tanks, many keeping a backup tank for groundwater. Tanks here are often older fibreglass prone to cracking at corners and base. We scrape and clean the crack site from algae and deposits, then weld the break with a fibreglass rod or replace the fitting if snapped. Extra pressure from the ground tank causes leaks from weak walls so we measure thickness first.
Abu Fatira sits in Mubarak Al-Kabeer governorate, a long-settled residential district where most homes have older tank systems needing regular maintenance.
We measure wall thickness with ultrasonic tools to determine if repair is safe or if the tank needs complete replacement.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Abu Fatira
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Abu Fatira
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do old tanks crack in Abu Fatira?
Old fibreglass tanks weaken from direct sun and constant water pressure. Algae and salt speed the damage. We clean the tank and inspect walls before deciding repair or replacement.
Must the tank be emptied before welding?
Yes, complete draining is necessary for safety and atmospheric pressure helps rapid drying. With large tanks we may leave a small amount at the base to fix position but never weld underwater.
