Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Rawdhatain
Tank welding in Rawdhatain repairs exposed tanks enduring extreme temperature swings between summer and winter. We search for cracks from thermal expansion and contraction in fibreglass and thick plastic. We clean the crack, sand the perimeter, perform precision welding to survive ongoing seasonal stress and test the repair under full pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Rawdhatain rooftop tanks stand unshaded in the protected natural area near underground springs, exposed to full sun from dawn to dusk. Temperatures rise above fifty degrees and drop sharply after sunset, and this daily range stresses the material and triggers microfractures. Fine cracks appear first at the seam lines where tank sections join, requiring close visual and tactile inspection before welding.
Rawdhatain sits in Jahra governorate near the protected natural springs, a unique conservation area where tank installation follows strict environmental limits.
We test every weld twice: first by sight for surface defects, then by filling the tank completely to confirm no seeping occurs.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Rawdhatain
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Rawdhatain
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do thermal cracks reappear after welding in the next summer?
Rarely, if we use a flexible welding rod rated for thermal cycling. But if the original cracks grew from structural weakness we may suggest external reinforcement strips of steel mesh.
Can we weld the tank during summer when temperatures peak?
Possible but not ideal, because hot metal cools unevenly after welding which may weaken the joint. We prefer spring or autumn work when temperatures are moderate and cooling is steady.
