Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Salam
Not every tank welding job in Salam is a repair. Homes near Salam Co-op often need a new outlet for a booster pump or a separate line, and we weld a proper fitting boss into the tank wall instead of drilling a hole and hoping a rubber washer holds.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
A tank wall is thin and curved, so a bulkhead fitting clamped through it can leak as soon as the plastic flexes. We choose the position on a flat section low enough for the pump to draw from, weld a thickened pad in matching plastic around the opening, and tap the fitting into that solid pad. The new outlet is set slightly above the tank floor so settled sediment stays behind rather than flowing into the pump.
Salam is a Hawalli governorate residential district whose homes and services centre on Salam Co-op.
New outlets we add in Salam sit on a welded pad, set just above the tank floor to avoid sediment.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Salam
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Salam
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a new outlet be added to my existing tank?
Yes, on most polyethylene tanks. We weld a thickened pad first, so the fitting sits in solid plastic rather than the thin wall.
Why not fit the outlet at the very bottom?
Sediment settles on the tank floor. Setting the outlet a little higher keeps that sediment out of the pump and the house pipes.
