Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Rumaithiya
Tank welding in Rumaithiya addresses joint leaks and small holes in plastic tanks on seafront villa roofs. We perform thorough pressure inspection to find every weak point, then weld it precisely and retest immediately.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Rumaithiya seafront villas have a 3 or 4 tonne plastic tank above the roof fed by booster pump or submersible pump, creating continuous stress on walls and fittings. The leak may be tiny at first, appearing as wet patches around the base or outlet, and widens under pressure if left. We cut the supply and drain fully, dry the tank inside and out, inspect all joints with a strong light and weld any cracks we find.
Rumaithiya lies in Hawalli governorate on the eastern coast, a modern seafront villa zone that relies on high-pressure elevated tanks.
We test the weld by refilling the tank and running the pump at full working pressure for ten minutes.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Rumaithiya
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Rumaithiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does high pump pressure cause leaks to worsen faster?
Yes, continuous pressure widens small cracks in the tank. After welding, we test under actual operating pressure to ensure the weld withstands full pressure with no new leaks.
Should the tank be replaced instead of welded?
No, welding is the first solution if the tank is sound overall and the leak is localized. Replacement comes only if there are multiple recurring leaks or if the tank wall is severely damaged.
