Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Nuqra
Tank welding in Nuqra serves family homes and apartment buildings relying on overhead tanks to store fresh water. We reach building roofs and examine tanks for cracks, corrosion or improperly welded ports from original installation. We test existing weld integrity by tapping and listening for a solid sound.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Modern Nuqra apartment buildings hold fibreglass tanks with insulation layer and protective colour to deflect sun. These tanks sit on metal frames atop roofs and bear huge water weight reaching tens of tonnes. Cracks usually appear around drain pipe ports or filter fittings or where tank meets the metal frame. During inspection we lift the tank slightly from the frame to check the underside and examine metal joints for rust.
Nuqra sits in Hawalli governorate near Salmiya, a built-up area crowded with mid-rise apartment buildings.
After tank welding we check frame metal joints with a moisture meter because humidity under the tank causes rapid rust.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Nuqra
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Nuqra
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a cracked fibreglass tank be repaired inside and outside in one visit?
Yes but requires full tank drainage and interior cleaning first. We patch the outside with resin then wait for cure before starting inside work.
Will the weld stay protected from UV rays and extreme heat?
Fibreglass weld is covered with an additional UV-blocking resin patch layer. This coating protects the weld and prevents secondary cracking for years.
