Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Salmi
Tank welding in Salmi repairs damage in plastic and fibreglass tanks that serve areas far from central water networks. We locate the leak, drain the tank enough, abrade the surface and seal cracks with tight weld.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Buildings in Salmi are scattered along the border and small settlements are far from public services, so each house relies on one or two water tanks fed by tanker trucks. Tanks face sharp temperature swings between day and night and strong northern winds. Stress cracks appear in corners and weak spots first, and small seeps worsen fast in heat. We inspect the tank from all sides, identify likely future cracks by spotting thin patches, and reinforce weak areas with double weld.
Salmi is a remote border area of Jahra governorate near the Kuwait-Iraq border, where homes depend entirely on separate water tanks.
We test Salmi tank welds under continuous pump pressure because tanks there receive high pressure from delivery tankers.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Salmi
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Salmi
Need someone now? The emergency line is open any hour.
+965 9668 4964
If we cannot fully drain the tank, can the crack still be welded?
Yes, but with more difficulty. We drain what we can, dry the area with a heat lamp, add absorbent material then complete the weld quickly before water returns. Testing takes longer.
Does Salmi's severe heat expansion affect fresh weld?
It affects it greatly, so we use flexible weld that allows slight movement. We test it under a heat lamp then let it cool naturally before refilling the tank.
