Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in West Abdullah Mubarak
Tank welding in West Abdullah Mubarak repairs loose joints between the tank and upper and lower pipes. We check every joint inside and out, reweld weak areas and test under steady pressure for two hours.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
In West Abdullah Mubarak, modern villas have medium fibreglass tanks on the roof with complex inlet and branch outlet systems. The inlet comes from the main supply line and branches to roof tank, bathrooms and kitchen, each pipe at a different angle and fall. When pipes move from wind vibration or heat changes, weld joints face stress and age quickly. We inspect every joint with a lamp, clean it with a wire brush and reweld weak spots.
West Abdullah Mubarak in Farwaniya governorate is a modern residential suburb with mostly new-built villas.
Before leaving, we run an empty-tank pressure test by draining and refilling slowly to check if any joint leaks again.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in West Abdullah Mubarak
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in West Abdullah Mubarak
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do joints around the tank leak even though they were welded recently?
Metal pipes and fibreglass expand at different rates in midday heat, stressing the weld. If the weld was weak from the start, it may fail within weeks.
Must we drain the whole tank to fix just one leaking joint?
Yes, because the joint must be completely dry and clean. If it is on the tank bottom we drain fully, but if it is higher we may drain only a portion.
