Camera inspection
internal filming before and after work to document tank condition
Ahmadi
Underground tank cleaning in Shuaiba Industrial
Underground tank cleaning in Shuaiba Industrial starts with a careful inspection of the tank walls, floor and outlet before any work begins. We pump out all old water, then wash deposits using high pressure and sanitise the interior with approved solution. After filling with fresh water, we test quality before the system runs.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most factories and warehouses in Shuaiba Industrial use large underground tanks buried beneath concrete floors, and these tanks accumulate mineral salts and chemical deposits from hard water. We inspect the access opening and internal strainers and check suction pipe integrity before pumping begins. After high-pressure washing we take a water sample for laboratory testing to confirm the tank is free of bacteria.
Shuaiba Industrial lies in Ahmadi governorate and houses the KIPIC petrochemical complex where facilities depend on reliable, sanitised water supply.
We test water pressure at every tank outlet because low pressure indicates deposits inside the pipes.
What the service covers
Sediment extraction
pump extraction of silt and settled deposits from the tank floor
High-pressure scrubbing
pressurised water removes algae, scale and biofilm from all surfaces
Tank disinfection
post-wash internal treatment to make water safe before refilling
Access hatch check
checking and resealing the hatch to prevent outside contamination
Post-work report
documented condition report handed to the property owner after cleaning
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Underground tank cleaning
Other services in Shuaiba Industrial
Epoxy tank lining
See the detailsFibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsCommon questions
Questions about Underground tank cleaning in Shuaiba Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
When should a factory or warehouse underground tank be cleaned?
Annual to biennial cleaning is recommended based on incoming water quality and tank size. If water appears cloudy or smells unusual, immediate cleaning is necessary.
Can the tank be used while cleaning and sanitisation happen?
No, water supply must be completely shut off until sanitisation and final rinsing are complete. We schedule a fixed time to finish as quickly as possible to minimise production downtime.
