Inspection and mapping
Internal camera maps every crack and spalled area before work starts
Ahmadi
Water tank restoration in Bnaidar
Water tank restoration in Bnaidar addresses corrosion from high-salinity water and salt evaporation. We locate damage points then apply chemical protection that resists salt and extends tank life.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Bnaidar tanks face extremely high salt concentration in groundwater and desert air, causing rapid corrosion of concrete and steel. We start with full visual inspection then measure wall thickness with ultrasound to assess damage. Surface corrosion gets stripped with power abrasion then sealed with salt-resistant coating. Deep concrete damage may need repair injection before coating or partial re-casting of broken sections.
Bnaidar is a desert zone in Ahmadi governorate where soil and groundwater salt levels far exceed normal rates.
We retest the tank thirty days after fresh coating to verify the protective seal holds under salt stress and heat.
What restoration covers
Surface preparation
All scale, efflorescence and loose material removed before any filler is applied
Crack filling
Hydraulic mortar seals active and dry cracks in concrete walls and floor
Wall levelling
Repair render restores corroded or pitted wall surfaces to a uniform face
Protective coating
Drinking-water rated coating applied over fully cured and prepared surfaces only
Post-work check
Camera confirms coating integrity and joint sealing before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank restoration
Other services in Bnaidar
Fibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsUnderground tank cleaning
See the detailsCommon questions
Questions about Water tank restoration in Bnaidar
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the tank need protection on the outside as well?
Yes, an external salt-resistant coating protects against salt creep from air and soil. The outside deteriorates fast in Bnaidar due to high salt concentration.
How often should the protective coating be renewed?
Every three to four years inspect the coating and reapply to damaged areas. Salt attacks the coating fast so regular maintenance is essential.
