Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Bnaidar
Tank welding in Bnaidar addresses cracks and failed joints on tanks exposed to wind and sharp climate swings. We fully inspect the tank, carefully weld cracks and verify there are no leaks under pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Water tanks in the desert Bnaidar zone suffer from intense wind and harsh seasonal climate swings. Wind shakes tanks hung on towers and metal frames, placing repeated stress on joints and the base. Cracks typically show as vertical lines when tanks sway hard in wind, often appearing in clusters in one area. We inspect every standard joint and welded seam and search for vibration marks and hidden cracks using coloured water under pressure.
Bnaidar sits in eastern Ahmadi governorate where strong winds and climate shifts affect the stability of hanging tanks.
We test the tank under gradually increasing pressure to ensure every new weld tolerates repeated stress from wind and vibration.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Bnaidar
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Bnaidar
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do wind-caused vertical cracks differ from horizontal cracks?
Yes, vertical cracks indicate repeated tensile stress from vibration, while horizontal ones suggest body bending. Both need strong welding but we position the weld based on stress direction.
How often should the tank be inspected after welding in Bnaidar?
We recommend a follow-up inspection after three months and another at six months to confirm no new cracks emerge from repeated vibration. Bnaidar winds may expose hidden weakness we missed in the first check.
