Inspection and mapping
Internal camera maps every crack and spalled area before work starts
Capital
Water tank restoration in Dasma
Water tank restoration in Dasma begins with a full inspection of the internal walls, floor, inlets and outlets. We identify cracks, leaks and deposits, then select structural repair, protective lining or both. The tank is water-tested before return to service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Dasma mixes old villas with roof-mounted tanks and apartment blocks with communal tanks in basements or on higher floors. Ageing villa roof tanks crack from direct sun and weather exposure, while older communal tanks near Dasma Co-op may hold mineral deposits that cloud the water. We remove deposits with stiff brushing and pressurised rinse, then apply epoxy lining inside to seal against rust.
Dasma sits in Kuwait governorate, a residential district near city centre where tanks of varying ages require different restoration approaches.
We test the tank under full water load for two hours before handover because small leaks worsen rapidly under pressure.
What restoration covers
Surface preparation
All scale, efflorescence and loose material removed before any filler is applied
Crack filling
Hydraulic mortar seals active and dry cracks in concrete walls and floor
Wall levelling
Repair render restores corroded or pitted wall surfaces to a uniform face
Protective coating
Drinking-water rated coating applied over fully cured and prepared surfaces only
Post-work check
Camera confirms coating integrity and joint sealing before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank restoration
Other services in Dasma
Fibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsUnderground tank cleaning
See the detailsCommon questions
Questions about Water tank restoration in Dasma
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you tell if cracks need structural repair or just protective coating?
Shallow surface cracks respond to protective lining, but cracks that widen when the tank fills or leak water need cement injection first. We fill slowly and watch each crack to see if it moves.
Must the tank be completely emptied before restoration work?
Yes, full drainage and venting for several hours is required before interior work and entry. Sediment and algae build-up must be cleared carefully, so we also pressure-clean from outside to reduce the internal load.
