Inspection and mapping
Internal camera maps every crack and spalled area before work starts
Ahmadi
Water tank restoration in Zour
Tank restoration in Zour focuses on thermal inspection to detect weakness under high pressure. We measure tank wall thickness with ultrasonic tools and inspect old welds for cracking. Heavy deposits and rust are removed with specialised equipment, then protective coating is applied with reinforced specification. The tank returns ready for pressurised, heated service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Power generation stations in Zour use water tanks under high pressure and continuous heat, and hot pressurised water accelerates chemical corrosion of aged lining. Metal and concrete tanks there endure daily thermal cycles from relative cool nights to extreme daytime heat, causing expansion and contraction that stress welds and joints. We pressure-test the tank before restoration and select coating rated for fluctuating temperature and sustained pressure.
Zour sits in Ahmadi governorate near the main power plant, an industrial zone of high pressure demand that requires advanced-capacity water tanks.
We pressure-test the tank with a manual pump before leaving site to ensure no joint leaks under actual operating load.
What restoration covers
Surface preparation
All scale, efflorescence and loose material removed before any filler is applied
Crack filling
Hydraulic mortar seals active and dry cracks in concrete walls and floor
Wall levelling
Repair render restores corroded or pitted wall surfaces to a uniform face
Protective coating
Drinking-water rated coating applied over fully cured and prepared surfaces only
Post-work check
Camera confirms coating integrity and joint sealing before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank restoration
Other services in Zour
Fibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsUnderground tank cleaning
See the detailsCommon questions
Questions about Water tank restoration in Zour
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do high-pressure tanks need more frequent inspections than standard tanks?
Yes, because sustained pressure accelerates corrosion and fine cracking. We recommend full inspection at least yearly and quick visual checks every three months for power stations.
If a small leak shows in a pressurised tank can it be patched locally?
Usually no, because partial repair under pressure may not hold and causes rapid failure. We prefer complete drainage and restoration of the affected area with inspection of other walls for similar weakness.
