Fill valve
Adjusted or replaced when filling is slow, noisy or never stops.

Farwaniya
Toilet cistern repair in Hassawi usually begins with a constant hissing after flushing or water pooling under the tank. We check the fill and flush mechanism, rubber seals and worn parts, replacing what has degraded. A full flush cycle is tested before we finish.
Hassawi's older houses often have the cistern mounted high on the roof or in a wooden cabinet directly behind the pan, with water fed down by gravity through thin plastic pipe. When the lower seal weeps, water runs straight onto the pan and floor. We disconnect the cistern from its brackets, remove the degraded seal, fit a new one and clean away mineral buildup before reassembling.
Hassawi lies in Farwaniya governorate, an older residential district where high-mounted traditional cistern design is common.
We test water shut-off after filling to confirm the float valve closes fully without ongoing seepage.
Adjusted or replaced when filling is slow, noisy or never stops.
Repaired when water trickles constantly from cistern to pan.
Set or replaced to restore the correct water level inside.
Checked and reseated when the joint leaks at floor level.
Broken or loose seats replaced on the same visit.
Wax or rubber seal replaced when water pools at the base.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
The hissing comes from the cold water inlet valve that refills the cistern after flushing. If it hisses for more than one minute, the float valve is stuck or the inlet seal has worn. We clear mineral deposits from the valve or replace it.
Not always. Cracks in the cistern are rare but seals and valves degrade quickly in hard water. We pressurize and run the empty cistern to locate where the leak is coming from exactly.
