New pipe runs
Cold and hot supply lines routed to fixtures and tanks.

Ahmadi
Water pipe runs at Zour serve power generation plants that consume huge volumes for cooling. We lay large-diameter lines across hard ground, inspect existing pipes and flush heavy sediment. Every run is pressure-tested at very high pressure before operation. We ensure steady uninterrupted flow to prevent cooling shutdown.
Zour power plants contain massive pipe loops connected to cooling towers and cold-water ponds. Pipes operate at very high pressure with diameters from 300 to 600 millimetres. We measure existing pipes and inspect them with video camera to find blockages and internal cracks. Where we find thick desert sediment deposits we flush with high-pressure water or run reverse flow. Old joints may leak under operating pressure, so we replace them with tight, sealed fittings.
Zour sits in Ahmadi governorate and houses a thermal power generation station requiring constant maintenance of its massive cooling network.
Main cooling lines are pressure-tested at 16 bar for two hours because any leak cuts cooling and shuts production down immediately.
Cold and hot supply lines routed to fixtures and tanks.
Leak located acoustically and by camera before any breaking.
Wrapping exposed or roof-level pipes against heat and condensation.
Removing mineral scale that narrows the pipe wall over time.
Targeted clearance of blocked supply lines without unnecessary breaking.
Internal camera pass and pressure check before pipes are concealed.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We use high-pressure water flow from one end and open the other for discharge. Where deposits are very thick we run a reverse pump to push sediment out, then flush again.
We pinpoint the crack location precisely and isolate that pipe section using valves on both sides. We cut and remove the damaged section, then install new pipe with tight, sealed couplings.
