Tank installation
Mounting the tank on a level concrete base to protect its base from cracking
Hawalli
Roof tank installation in Anjafa
Roof tank installation in Anjafa starts with checking the structural strength and distance from the main supply line. We position the tank to ensure adequate fall to lower pipes, secure it on concrete foundations, connect inlet outlet and overflow, then pressure test the system.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Anjafa residential houses have flat strong roofs that bear substantial loads, allowing large-capacity tank installation. We measure the available depth from the roof structure and verify weight distribution across a solid base with no voids beneath corners. We trace the supply pipe length from the nearby pump station and test inlet pressure under full load.
Anjafa is located in Hawalli governorate, a residential district where most houses rely on roof tanks to stabilize daily water pressure.
Every installed tank is tested by full fill and left static for one hour to detect leaks at all welded joints.
What the installation covers
Inlet and supply lines
Running the fill line and distribution line to floors in PPR pipe
Overflow and drain line
Installing the overflow at correct slope so no water pools on the roof
Pump connection
Connecting the existing transfer or pressure pump and setting its switch
Float valve fitting
Fitting a brass float valve sized to the tank for accurate fill cut-off
Pressure test
Testing all joints under pressure before handover to confirm no leaks
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Roof tank installation
Other services in Anjafa
Underground tank construction
See the detailsAcoustic leak listening
See the detailsApartment first-fix
See the detailsBasement sump pump
See the detailsCommon questions
Questions about Roof tank installation in Anjafa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the roof level need to be raised to support the tank safely?
We first assess the existing roof strength using distributed load testing. If adequate, we fix the tank directly on localized concrete foundations without raising. If the roof is weak, we recommend additional steel supports.
What is the difference between the inlet line and the overflow pipe?
The inlet carries water from the pump station into the tank, while the overflow diverts excess water to the public drain when the tank is full. We fit a float valve on the inlet to cut off flow automatically when full.
