Tank installation
Mounting the tank on a level concrete base to protect its base from cracking
Capital
Roof tank installation in Qibla
Roof tank installation in Qibla starts by hoisting the tank to the roof via stairs or winch depending on size and access. We choose a position near the main water lines, set concrete supports, connect supply inlet overflow and draw-off, then test under pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Modern Qibla residential towers have tight roof spaces shared with air-conditioning pipes and ductwork. We plan the horizontal pipe run to avoid crossing existing drainage lines and raise the supply point above other services. A tank set away from the main roof opening needs extra bracing of its base because load is spread over limited area.
Qibla sits on Kuwait Bay near Seif Palace, a commercial and high-rise residential zone where roof space is tight and tanks stand beside other equipment.
Every joint is held under steady water pressure for twenty minutes before the tank is opened for normal use.
What the installation covers
Inlet and supply lines
Running the fill line and distribution line to floors in PPR pipe
Overflow and drain line
Installing the overflow at correct slope so no water pools on the roof
Pump connection
Connecting the existing transfer or pressure pump and setting its switch
Float valve fitting
Fitting a brass float valve sized to the tank for accurate fill cut-off
Pressure test
Testing all joints under pressure before handover to confirm no leaks
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Roof tank installation
Other services in Qibla
Underground tank construction
See the detailsAcoustic leak listening
See the detailsApartment first-fix
See the detailsBasement sump pump
See the detailsCommon questions
Questions about Roof tank installation in Qibla
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the tank be installed on a roof that already has air-conditioning pipes?
Yes, but we plan the new water lines carefully to avoid crossing cooling pipes and drains. We position the inlet high enough that future maintenance work on other equipment won't disturb it.
How long is the pipe run from the tank to the apartments?
We measure the vertical and horizontal distance from the tank position to the main distribution riser, then calculate the pipe length needed. Long runs need intermediate brackets to prevent sagging under water load.
