Electronic detection
sensors detect escaping gas through walls without any breaking
Mubarak Al-Kabeer
Gas leak detection in Qosor
Gas leak detection in Qosor requires checking the full run from the meter entry to every appliance because pipes sometimes span multiple floors. We listen with a test pipe, use an electronic detector to pinpoint the spot, then repair by drying, heating and soldering or by replacing the section.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Many apartment buildings in Qosor have multi-floor units with lounge, oven, hob and gas water heater at minimum, all connected by copper branches from one main line. We check the primary runs first and wait for pressure to settle to rule out major leaks, then isolate and test each branch at its split point. Small leaks in wall-hung joints may only alert residents by smell, so we use a wall mirror and short-breath detector passes to locate them.
Qosor sits south in Mubarak Al-Kabeer governorate, a district known for mid-rise apartment blocks and small shops.
Before repair, the pipe is inspected under strong light because debris and sediment block the detector and give false readings.
What this service covers
Pressure test
network segments isolated and pressure drop measured to find the faulty section
Joint inspection
every joint and valve checked with leak-detection fluid where leakage is suspected
Source isolation
gas isolated to the faulty section immediately to keep the building safe
Line repair
only the damaged section repaired or replaced, rest of network left intact
Final pressure check
full pressure test after repair confirms the entire network is tight
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Gas leak detection
Other services in Qosor
Kitchen gas lines
See the detailsRestaurant gas lines
See the detailsCentral gas first-fix
See the detailsPlumbing installations
See the detailsCommon questions
Questions about Gas leak detection in Qosor
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does the gas smell move between rooms in the same apartment?
Because pipes are hidden in walls and ceilings and odour leaks from the break point then spreads through vents and door gaps. A strong smell in the kitchen does not mean the leak is there.
Can a damaged pipe under tiles be fixed without breaking the floor?
If the leak is in a hung joint below ceiling, yes, we can ease the pipe out and reroute it. If it is under tiles we need a short cut to access the copper for cleaning, soldering or replacement.
