Cold water supply
PPR runs to every tap, cistern and appliance point in the unit
Ahmadi
Apartment first-fix in Maqwa
Apartment piping in Maqwa starts by assessing the flat's position relative to the main central drainage stack in the building. We run copper pipes for hot and cold supply and connect bathroom and kitchen drains at a steady slope. We test cold and hot water pressure separately then together before leaving.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Maqwa is a residential area with modern apartment blocks holding small to medium flats for staff and workers. Most blocks have one main bathroom and a separate guest bathroom, meaning two parallel drain lines must slope toward the central stack at the same speed. We measure distance precisely and set pipe lengths to ensure both lines reach required water pressure simultaneously.
Maqwa is a staff residential district in Ahmadi governorate located closer to national oil company fields.
We test the drain by running cold salt-flush solution from twelve metres height because that simulates maximum flow from an upper floor flat.
What the first-fix covers
Internal drain runs
uPVC drain lines graded to prevent standing water and blockages
Bathroom stub-outs
Waste and supply stubs positioned accurately before screed is poured
Kitchen connections
Supply and waste points for sink, washing machine and refrigerator
Pressure testing
Recorded pressure test on the supply network before walls are closed
Tank and pump tie-in
Connecting the unit's supply line to the building tank and pump system
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Apartment first-fix
Other services in Maqwa
First-fix plumbing and electrics
See the detailsKitchen first-fix
See the detailsBathroom first-fix
See the detailsDrainage first-fix
See the detailsCommon questions
Questions about Apartment first-fix in Maqwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the main bathroom and guest bathroom drain lines meet at one point or must they stay separate?
They can meet but only at a point very close to the main stack. If they join too early, water from one bathroom can back up into the other if blocked.
How many times is pressure testing done before final handover?
At least three times: first on cold water alone, second on hot water, and third on both together. Each test runs fifteen minutes with no gauge drop.
