Hot and cold supply points
PPR lines routed precisely to basin, shower and toilet positions
Capital
Bathroom first-fix in Daiya
Bathroom rough-in in Daiya begins by mapping all supply and waste runs before walls close. We route hot and cold from the roof tank to every fixture point, raise waste lines on a steady fall toward main stacks and test pressure and flow before boarding. Proper rough-in this way prevents hidden leaks and foundation damage later.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Modern homes in Daiya near British School need multiple bathrooms with separate fixtures: the main bathroom for the family requires a shower and basin, the second bathroom and kitchen each need a single tap. We run separate supply lines from the roof tank instead of combining them, because pressure drops if we squeeze multiple feeds through one narrow pipe. Waste from each bathroom must fall toward the main stack in the ground floor without cramping pipes into concrete walls.
Daiya lies in Kuwait governorate, an area with modern building stock where reinforced concrete slab foundations are the standard.
Every supply line is pressure-tested at 3 bar for 30 minutes before bathroom handover, because slow leaks only show under full pressure.
What the rough-in covers
Bathroom waste lines
uPVC drain runs laid at correct fall to prevent standing water
Floor trap installation
Floor trap levels set before screed to align flush with final tiling
Vent connection
Connecting the waste run to the vent stack prevents trap siphoning and odour
Pressure test
Documented pressure test on supply lines before walls are permanently closed
Point positions record
All supply and waste point locations recorded for finishing and future maintenance
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Bathroom first-fix
Other services in Daiya
First-fix plumbing and electrics
See the detailsKitchen first-fix
See the detailsApartment first-fix
See the detailsDrainage first-fix
See the detailsCommon questions
Questions about Bathroom first-fix in Daiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can all bathroom taps be fed from a single tank outlet?
No, pressure will drop if more than one tap opens at once. We raise two separate pipes from the tank to the main bathroom and a third to the kitchen, keeping flow steady at every point.
When are waste pipes tested?
Once each waste pipe is fixed we pressurize it with air at 10 cm water gauge to check for cracks, and after walls are sealed we fill the pipes with water to test flow and fall. Two tests ensure no faults before the bathroom is used.
