Waste outlet check
Height and position confirmed before the shower tray is set.

Ahmadi
Chrome that pits and peels early is a familiar sight in flats along Mahboula's seafront, so shower installation in Mahboula starts with the choice of metal. Near Mahboula Co-op and Beach Road block 12, we favour solid brass bodies with durable finishes.
Cheaper showers often use zinc alloy or plated plastic under a thin chrome layer, and salty, humid air finds any weak spot in that coating. Solid brass bodies with a thick chrome or PVD finish hold up far better. In Mahboula apartments we also use stainless steel hoses and brackets, and advise rinsing with plain water and wiping dry, since abrasive cleaners also wear the finish down.
Mahboula is an Ahmadi governorate district of seafront apartment towers, with Mahboula Co-op and the Beach Road stretch of block 12.
Near the sea we fit solid brass shower bodies with stainless hoses rather than plated alloy sets.
Height and position confirmed before the shower tray is set.
Tray levelled and trap sealed with a rubber gasket.
Hot and cold lines connected to the mixer with isolation valves.
Mixer and arm fitted with thread sealant on every joint.
All tray-to-wall edges sealed with non-fungal sanitary silicone.
Water run and full drainage confirmed before handover.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
It is a thin, hard coating bonded to the metal in a vacuum process. It resists scratching and tarnish better than standard plating.
Rinse with water, wipe dry and use a mild soap. Avoid scouring pads and strong acid or bleach cleaners on metal parts.
