Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Jahra
Epoxy tank lining in Amghara
Epoxy coating for tanks in Amghara faces a special challenge because the area is close to industrial zones where salt and particle concentration in groundwater is high. We prepare the tank with complete drainage and thorough cleaning, then apply a thick epoxy layer that resists highly mineralized water exposure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Amghara is a residential area located near Jahra industrial zones, which means groundwater around underground tanks contains high concentrations of salts and mineral elements. This water seeps slowly through old concrete walls and deposits on the tank interior surface, reducing storage efficiency. Epoxy creates a complete barrier that protects against this seepage and preserves the purity of stored water.
Amghara is a residential neighborhood in Jahra governorate near industrial zones, where groundwater is rich in minerals and salts.
A groundwater sample around the tank is collected before coating to test mineralization level and determine appropriate coating thickness.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Amghara
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Amghara
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does epoxy protect against salty groundwater that may seep from soil?
Yes, epoxy is specifically designed to resist salty and mineralized water. We apply an extra-thick layer in Amghara because salt concentration is higher than in other Jahra areas.
How often should epoxy coating be renewed in Amghara tanks?
Epoxy coating lasts at least ten years under normal conditions, but in Amghara where mineralization is high, renewal may be needed after eight years. We inspect the tank every two years to check the coat condition.
