Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Amghara
Tank welding in Amghara addresses larger tanks serving residential blocks and light industry nearby. We inspect cracks and seepage from the ground up and pressure-test every weld with water.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Amghara tanks are usually large fibreglass units on concrete pads feeding residential blocks and shops. The issue here is that fill and drain fittings are multiple and may be under high water pressure all day. We inspect every fitting closely and test whether it leaks slowly or fast because slow seepage may not show except under full pressure. We weld weak fittings and retest them under running water.
Amghara lies near Jahra industrial zone, where large tanks with varied use are common.
We test fibreglass welds by pumping live water for at least thirty minutes because fittings face constant daily pressure.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Amghara
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Amghara
Need someone now? The emergency line is open any hour.
+965 9668 4964
If the tank leaks from several fittings at once can we repair them all together?
Yes, we open and clean each fitting and inspect it before rewelding. We test each one individually under running water after repair to confirm the seal holds.
Is cold welding safe for an industrial water tank under high pressure?
Cold welding works for small cracks and non-critical fittings. For high pressure we use hot welding or replace the fitting entirely if it is damaged.
