Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Farwaniya
Epoxy tank lining in Khitan Al-Jadida
Epoxy tank lining in Khitan Al-Jadida starts by draining the tank and scraping the walls until the surface is rough for adhesion. We clean dust and moisture, then apply two coats of epoxy with wide brushes. We inspect the coating with an internal camera before refilling.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Khitan Al-Jadida homes have small roof-mounted tanks or underground tanks beneath the kitchen. These tank walls face rust because the hard water in Farwaniya leaves scale deposits and causes surface corrosion. An epoxy coat forms a waterproof barrier between the water and steel, protecting the tank interior for years without water discolouration.
Khitan Al-Jadida lies in Farwaniya governorate, a modern residential district where overhead and ground tanks are common in every home.
Before coating, surface moisture is tested with a meter because excess dampness prevents epoxy from bonding.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Khitan Al-Jadida
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we know if a tank is rusty enough to need epoxy coating?
We take a water sample and check for brown tint or metallic smell. If rust stains or corrosion spots are visible on the inner walls by eye or camera, coating is needed.
Can we use water from the tank right after the epoxy dries?
We allow 24 hours for curing, then fill the tank and let it sit for 48 hours before use. This ensures the coat sets fully and any odour fades completely.
