Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Jahra
Epoxy tank lining in Sulaibiya Industrial
Epoxy lining in Sulaibiya Industrial resists high temperatures and continuous load on large storage tanks. We fully drain the tank, scrape the interior aggressively, apply industrial epoxy and pressure-test before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Industrial area tanks suffer faster corrosion due to treated water use, light chemicals and temperatures reaching sixty degrees. Most tanks here are buried or covered by large metal frames, which makes work harder because ventilation is limited and corner access is difficult. We use powerful mechanical scrapers to reach every centimetre and dry surfaces with compressed air before coating.
Sulaibiya Industrial Area in Jahra governorate houses production facilities and large-capacity storage tanks.
High-definition camera inspection after coating detects any air pockets or layer weakness before tank use.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Sulaibiya Industrial
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Sulaibiya Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the epoxy withstand temperatures above sixty degrees Celsius?
Industrial-grade epoxy here is rated higher but does not withstand more than 65 degrees for extended periods. If storage heat exceeds that we recommend external thermal insulation or reflective coating.
Must the factory shut down during the entire lining period?
Yes, the tank must be completely isolated from water, power and production lines for four full days. We schedule work around planned shutdowns to minimise production impact.
