Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Sulaibiya Industrial
Tank welding in Sulaibiya Industrial strengthens tanks used in manufacturing, washing and cooling against leaks and sudden failure. We inspect connection pipes to heavy machinery, clean weld heads of salt and oxide, weld cracks with localized heat transfer and industrial pressure test before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Factories and plants in Sulaibiya Industrial zone near the main Jahra road install multiple metal and plastic tanks of varying sizes connected by heavy pipes on workshop roof structures. Metal tanks corrode internally if water is acidic or carries heavy metals, and cracks appear at vibration points from heavy machinery. We sample the water before welding to determine acidity and expected corrosion, because welding alone is useless if water will eat the walls from inside.
Sulaibiya Industrial zone in Jahra houses factories, labs and processing plants where large tanks withstand high pressures.
After welding, every tank is pressure tested at fifty-one pascals for ten minutes because factories require strict safety standards.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Sulaibiya Industrial
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Sulaibiya Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does welding protect a metal tank from internal rust?
Welding seals external leaks only and does not stop internal rust. We recommend a corrosion-resistant internal coating after welding if water is acidic or contains sulphates.
What is the maximum crack length that can still be welded rather than replaced?
Cracks up to fifteen centimetres can be welded if they run straight and do not branch. Intersecting or branching cracks indicate structural fatigue and require tank replacement.
