Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Abdullah Mubarak
Tank welding in Abdullah Mubarak focuses on large fibreglass tanks serving several villas. We lower the tank from its position, open the cracked area, weld the fibre and resin, and test with full filling.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Homes in Abdullah Mubarak near the Co-op share one large roof tank between four or five villas. A single fibreglass tank takes high pressure from a split into multiple branches, and uneven pressure causes cracks in the bottom section where stress concentrates. When such a tank leaks, service to all villas must be cut because we need the tank completely empty before work starts.
Abdullah Mubarak in Farwaniya governorate near the Sixth Ring Road, where shared villas use large central tanks.
The repaired tank is tested at steady pressure for three hours before reconnecting because fine fibreglass cracks may widen slowly.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Abdullah Mubarak
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Abdullah Mubarak
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can we fix the tank without cutting water to all the villas?
No, the tank must be completely empty before we open it. We notify residents a day before so they can collect water in small backup tanks or containers.
If cracks exist in several spots, is the repair safe?
We weld each crack separately, but if there are more than three cracks spread across areas, the tank itself may be too weakened. We test at full pressure after repair and tell you if replacement is safer.
