Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Sulaibiya
Tank welding in Sulaibiya tackles cracks leaking from large plastic tanks exposed to harsh sun and extreme heat. We locate the leak by filling and pressure testing, then repair cracks with thermal welding, clean corroded joints and re-test the seal before use.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
In Sulaibiya, homes and farms rely on raised plastic tanks mounted on building roofs or metal frames near Sulaibiya Co-op. These tanks endure daily expansion and contraction from temperature swings between morning and evening, causing fine cracks at the original welds. We inspect every joint for deformation or thinning in the plastic wall, because a weak tank at one point can fail under pressure.
Sulaibiya is a desert area in Jahra governorate where groundwater is shallow and raised tanks are the only reliable way to store fresh water.
After welding, the tank is filled to capacity and monitored for an hour because internal pressure reveals hairline cracks.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Sulaibiya
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Sulaibiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can multiple cracks in one tank be repaired?
Yes, we weld each crack separately and pressure test after each repair. If cracks cluster too closely or ring a single joint, they signal structural weakness that may require tank replacement instead.
When is a tank too damaged to repair and needs replacing?
If cracks exceed three or any single crack runs longer than ten centimetres, further welding may not last. We inspect the entire tank and give you an engineering report before you decide on repair or replacement.
