Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Bayan
Large Bayan villas often link several roof tanks through one manifold, and tank welding in Bayan frequently targets the connection points rather than the tank body. Rigid pipes between tanks pull on the outlets every time the plastic expands in the sun, until a fitting boss cracks.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
On the roofs of the villa streets behind Bayan Co-op, we see manifolds built in rigid pipe with no allowance for movement. We weld the cracked boss back to full thickness, fit a new threaded insert, and replace the short rigid link with a flexible braided connector so the tanks can move independently. Each tank is then filled and left standing while we check every joint along the manifold.
Bayan is a Hawalli governorate villa district around Bayan Palace and Bayan Co-op, with large multi-tank rooftops.
When a Bayan manifold boss cracks, the rigid link beside it is replaced with a flexible braided connector.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Bayan
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Bayan
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do cracks keep appearing at the same fitting?
Usually because a rigid pipe is pulling on it as the tank expands and contracts. Welding alone will not stop it until that link is made flexible.
Can one tank be isolated while another is repaired?
Yes, if the manifold has valves on each branch. If not, we can add them during the repair.
