Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Bnaid Al-Qar
Tank welding in Bnaid Al-Qar repairs leaks and cracks in plastic tanks exposed to salt-air corrosion. We locate the leak, carefully dry the surface, weld the crack tightly and test the seal before service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Bnaid Al-Qar is a beachfront area near the old airport road where villas and apartments use plastic tanks exposed to salt spray and humid air. Salt eats the tank exterior and thermal expansion from sun creates internal cracks. We inspect inside and out, wipe away salt deposits with a damp cloth, wait for complete drying and weld the crack with low heat to preserve plastic strength.
Bnaid Al-Qar sits on Kuwait governorate's waterfront near the old airport road, where humidity and salt exposure are intense.
Before welding, we treat the surface with salt-removing solution for fifteen minutes then dry the tank with hot air.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Bnaid Al-Qar
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Bnaid Al-Qar
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does salt weaken a fresh weld?
Yes, if the surface is not thoroughly cleaned beforehand. Salt traps moisture beneath the weld causing internal corrosion. We clean meticulously and dry completely.
How often should a coastal tank weld be inspected?
At least every six months, as salt and humidity gradually re-open the weld. We recommend annual full inspection and weld renewal every two years if feasible.
