Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Dasman
Tank welding in Dasman fixes cracks and leaks in plastic and fibreglass tanks on rooftops and upper floors of apartment blocks. We locate the crack by careful inspection, prepare the surface and weld it from both sides until the tank holds again.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
In Dasman high-rise apartment blocks usually have a tank on the roof, and checking for leaks from it becomes a monthly issue for residents. When old weld seams holding the tank walls together crack, or the walls split from vibration and heat, water seeps through to ceilings below. We reach the roof, scrape the crack free of paint and rust, and run a welding torch over fine splits and weak joints until they fuse solid again.
Dasman sits on the Arabian Gulf waterfront and contains high-rise residential towers with water tanks spread across rooftops near Dasman Palace.
After welding, we fill the tank to test the weld under the pressure of real water load.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Dasman
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Dasman
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can an old plastic tank be welded or must it be replaced?
It depends on the tank age and crack location. If the damage is in the original weld and the walls are sound, we weld it. If the plastic has degraded from sun exposure, replacement is safer.
How long does rooftop tank welding take?
A single crack in a wall seam takes one to two hours depending on crack length and plastic thickness. Multiple cracks or leaks from several joints may need half a working day.
