Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Shuwaikh
Tank welding in Shuwaikh usually starts when an old joint or crack in the plastic walls lets water out. We locate the leak under pressure, clean the area around the crack, weld it with a specialist rod and test the tank before restart.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuwaikh has many residential buildings and small shops, each with a tank on the roof or in a yard, and these tanks face ultraviolet rays and sharp temperature swings. A small crack may start at a feed joint or overflow outlet and widen over years until the tank loses pressure. We also inspect the brackets and base because a loosely mounted tank shakes itself as it fills.
Shuwaikh lies in Kuwait governorate near Shuwaikh Port, a mixed residential and commercial area where most residents rely on rooftop tanks.
Each welded tank is tested by full fill and four-hour hold with no visible pressure loss because even slow seepage shows as dew on the outer wall.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Shuwaikh
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Shuwaikh
Need someone now? The emergency line is open any hour.
+965 9668 4964
Will welding make the tank like new again?
Welding stops the current leak and restores tank pressure, but if the tank is very old there may be other hidden cracks. We pressure-test to confirm the tank now holds without loss, and if other leaks appear we repair them immediately.
Can you weld a plastic tank while it is connected to the house pipes?
The feed and overflow valves must be shut first to empty the tank completely before welding. We reopen them after testing, and for large tanks we may need a temporary cut at the main supply.
