Crack welding
direct thermal weld along each fracture line in the tank wall

Capital
Tank welding in Mubarakiya Camps treats old metal and plastic tanks serving shops and stores near the Mubarakiya market. We reach the roof or back courtyard and inspect the tank from all angles. We pinpoint the leak by spraying water and watching for seepage. We clean the area and remove rust if present, then weld the crack using the method suited to the material.
Mubarakiya Camps tanks include old corroded metal ones because of salt and moisture near the central market. We inspect the metal for active rust spots and weakness around nickel-plated joints. Older plastic tanks there may be poor quality and brittle. We use a wire brush on metals then weld with metal or plastic rod depending on the case. We sand-blast rust sometimes on sensitive parts.
Mubarakiya Camps near the Mubarakiya market in central Kuwait City, where tanks serve long-established shops and workshops.
Metal tanks are checked with an electromagnet to detect thin metal under rust before welding.
direct thermal weld along each fracture line in the tank wall
re-welding inlet and outlet fittings where the flange joint has failed
resin-and-mat layer over the damaged zone before the final weld seal
internal camera after welding reveals any weak point before refilling
replacing the tank lid when the leak source is the cover seal
written record of weld locations and camera inspection result
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
If rust is deep inside it may not take additional welding. We send a small camera first to see remaining metal thickness. If too thin we may suggest tank replacement instead of repair.
Yes, metal welding leaves a raised line where the filler meets the base metal. We grind and smooth this line where possible. Then we paint the spot with rust-proof paint so it does not corrode again.
