Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Sulaibiya Agricultural
Tank welding in Sulaibiya Agricultural addresses failures of massive tanks installed to supply water to fields and livestock year-round. We test distribution lines and drains under pressure, then weld cracked joints, lubricate metal fittings and test the secondary outlet before restart.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Farms and animal pens near Sulaibiya Agricultural centre use fibreglass tanks exceeding ten thousand litres, with submerged pumps and buried distribution lines. Constant pump pressure and seasonal demand swings stress the welds at joint heads, especially around cleaning and drain ports. We measure tank wall thickness from outside with ultrasonic kit before welding, because fibreglass loses strength gradually under ultraviolet light.
Sulaibiya Agricultural in Jahra is a zone of fields, farms and poultry operations where large tanks run continuously through the season.
Every weld is tested by high-pressure pumping and pressure monitoring for nine hours because agricultural tanks cannot tolerate slow leaks.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Sulaibiya Agricultural
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Sulaibiya Agricultural
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a large fibreglass tank be welded without draining it completely?
Upper joints can be welded with partial water if cracks sit at least thirty centimetres above the current water level. Underwater cracks require full drainage because moisture weakens thermal weld quality.
How many times is the tank tested after welding?
Three times: each individual weld with electric pressure test, then the full tank with real pump flow for six hours, and finally twenty-four hours after restart to confirm weld stability.
