Wall position check
Marking the correct height and anchor points before any drilling
Capital
Wall-hung basin in Dasma
Wall-hung basin installation in Dasma starts by finding a load-bearing wall that can take both the basin weight and the waste line. We trace existing pipes behind the tiles and pick a height that works for all users in the bathroom. We run hot and cold supply from the nearest feed point and connect the waste to the floor trap or horizontal stack. Every joint is pressure-tested before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Old Dasma houses have small guest bathrooms on the ground floor, sometimes with old pipework running through the walls. Before fitting we check the wall thickness with a gauge and avoid pipes running near the surface. A wall-hung basin takes up less floor space than a pedestal, which matters in compact bathrooms. We choose a steel carrier frame with heavy bolts that handle dynamic weight during use. We load-test the bracket at five times the expected weight before securing the basin.
Dasma sits in Kuwait governorate near the city centre, an older residential area where bathrooms are compact and walls are sometimes thin.
We test every joint under running water for ten minutes because old walls may have fine cracks hidden behind tiles.
What the installation covers
Bracket installation
Fitting wall brackets rated to carry the basin weight safely
Supply line connection
Connecting hot and cold lines with new isolation valves fitted
Trap and waste fitting
Setting a new trap and connecting to the waste run at the right fall
Mixer and fittings
Fitting the mixer, strainer and all trim with sealed connections
Pre-handover test
Pressure check, waste flow test and full leak inspection before leaving
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Wall-hung basin
Other services in Dasma
Western toilet
See the detailsAblution basin
See the detailsBathtub installation
See the detailsJacuzzi installation
See the detailsCommon questions
Questions about Wall-hung basin in Dasma
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can old Dasma walls safely hold a wall-hung basin bracket?
Yes, but we must first measure wall thickness and test strength with a pilot bolt. If the wall is thin we use a carrier with long fasteners that drive through the brick to the concrete column behind.
How long does fitting take in a small bathroom?
Usually four to five hours from tracing pipes to final testing. If we find old pipework in the way or a weak wall, an extra hour may be needed to reroute the waste line.
